Skip to main content

npcil 2019 Exam paper SA/ST CAT - 1 (electrical) (part - 1)


NPCIL 2019 Exam paper
SA/ST CAT-I (Electrical)

 Question No. 1
The maximum temperature permitted in Class A insulation is
A) 180° C             B) 155° C
C) 120° C              D) 105° C
 Answer Key: D Your


Question No. 2
MHCP in illumination stands for
A) Median Horizontal Candle Power                B) Mode Horizontal Candle Power
C) Mean Horizontal Candle Power                   D) Meridian Horizontal Candle Power
Answer Key: C

Question No. 3
___________ states that a current will be induced in a conductor which is exposed to a changing magnetic field.
A) Faraday’s law                    B) Lenz’s law
C) Gauss’s law                        D) Maxwell’s law
Answer Key: A


Question No. 4
A Cathode Ray Oscilloscope gives __________ representation of the time varying signals.
 A) Actual             B) Approximate
C) Visual               D) Incorrect
Answer Key: C

Question No. 5
________ Type of lamp holder is fitted directly on the wooden board, which itself is fixed on the wall
A) Bracket           B) Angle
C) Pendant                    D) Batten
Answer Key: D


Question No. 6
Which of the following is/are the advantages of the parallel operation of an alternator?
A) Load supply can be increased            B) High efficiency
C) Operating cost is less                           D) All of the options
Answer Key: D

Question No. 7
A circuit that contains a pure resistance connected in series with a coil having pure inductance is known as
A) RLC series circuit                         B) RL series circuit
C) RC series circuit                           D) LC series circuit
Answer Key: B

Question No. 8
If three resistors of equal resistances (R) are connected in series, then the equivalent resistance will be
A) 3R                                 B) 1R
 C) 0.666 R                        D) 0.333 R
 Answer Key: A


Question No. 9
Which of the following features of an induction motor helps in preventing cogging of the motor?
A) High slip                    B) Large number of poles
C) Use of better insulating materials               D) Skewed slots
Answer Key: D

Question No. 10
Which of the following does NOT affect resistance?
 A) Mass              B) Resistivity
C) Cross-sectional area                   D) Length
Answer Key: A


Question No. 11
The Power transformer is used to transfer _______ energy in any part of the electrical or electronic circuit between the generator and the distribution primary circuits.
 A) Mechanical             B) Electrical
C) Heat                 D) Chemical
Answer Key: B

Question No. 12
The resolution of an indicating instrument is
A) The smallest change in the output reading due to drifting of the pointer
B) The smallest change in the input signal which can be detected by the instrument
C) The difference between various readings for the same applied stimulus
D) To faithfully indicate the value of the measured signal
Answer Key: B

Question No. 13
______ Theorem states "A branch of a network carrying a current of I amperes can be replaced by a voltage source of value IZ volts where Z is its branch impedance, without affecting the other parts of the network".
 A) Reciprocity              B) Thevenin
 C) Maximum power transfer                  D) Substitution
Answer Key: D




Question No. 14
Two electric lamps of 30 W each are connected in parallel. What is the total power consumed?
A) 15 W                         B) 45 W
 C) 60 W                         D) 75 W
Answer Key: C

Question No. 15
Which of the following single phase motor has the low starting and running torque?
A) Shaded pole             B) Reluctance
C) Hysteresis                 D) Universal
Answer Key: A

Question No. 16
____ Law states that the voltage induced in the coil is proportional to the rate of change of lines of force that pass through the coil.
A) Biot-Savart's            B) Ohm's
C) Faraday's                  D) Lenz's
Answer Key: C


Question No. 17
______ Theorem is used to combine a number of voltage sources connected in parallel into a single equivalent voltage source
 A) Norton's                  B) Tellegen's
 C) Millman's                 D) Thevenin's
Answer Key: C

Question No. 18
EPROM stands for
A) Erasable Programmable Read Only Memory
B) Editable Programmable Read Only Memory
C) Editable Programmable Random Only Memory
D) Erasable Programmable Random Only Memory
Answer Key: A

Question No. 19
The residual flux density is also known as
A) Residual induction            B) Residual magnetic induction
C) Residual magnetism         D) All of the options
Answer Key: D


Question No. 20
RMS in terms of electricity stands for
A) Root Mean Sum                B) Root Mean Square
C) Root Maximum Sum        D) Root Minimum Sum
Answer Key: B
link my channel 
https://www.youtube.com/channel/UCDik3D0Z3yHr6I7ra9lBtUw

Comments

Popular posts from this blog

NPCIL EXAM PAPER ELECTRICAL 2019 SA POST (PART-2)

NPCIL 2019 Exam paper SA/ST CAT-I (Electrical)                                                                             Hiren channel                                                                       (Electrical knowledge bank) Question No. 21 Transmission efficiency is the ratio of A) Power input/Power output       B) Power output/Power input C) Power input/Voltage drop     ...

MGVCL VS JE EXAM PAPER-2016 [“D” code]

MGVCL VS JE      EXAM PAPER- 2016 [“ D ” code]    (Madhya Gujarat vij company ltd) Question No- 01 A series motor is best suited for driving (A) Lathes                                  (B) Cranes and hoists (C) Shears and punches         (D) Machine tools Answer:-B Question No- 02 The phenomenon of rise in voltage at the receiving end of the open-circuited or lightly loaded line is called the (A) See beck effect       (B) Ferranti effect (C) Raman effect          (D) None of the above Answer:-B Question No- 03 An unsaturated shunt motor runs at its rated speed when rated voltage is applied to it. If the supply voltage to the motor is reduced by 25% the speed of...